Mazda MX-6 1998, Руководство по ремонту

Страница: 488 / 1282

EMISSION SYSTEM
15. Set the SST to port B as shown in the figure.
16. Verify that there is airflow from port D when
pressure of +0.98 kPa {+7.4 mmHg, +0.29 inHg}
is applied to port B.
Note
• Airflow amount is small on this step.
17. If there is no airflow, replace the pressure control
valve.
49 U 014 001
W 6 U 1 1 6 W A 8
CHARCOAL CANISTER INSPECTION
1. Remove the charcoal canister.
2. Plug ports A and B, then blow air into port C.
3. Verify that there is no air leakage.
W 6 U 1 1 6 W 0 6
7.9—10.7 N m
{80— 110 kgf-cm,
69.5—95.4 In lbf)
2.0— 3.9 N-m
{20— 40 kgf-cm,
18—34 In lb f)
8.9— 12.7 N-m
{90— 130 kgf-cm,
79— 112 in lb f)
A
7.9—10.7 N-m
{80— 110 kgf-cm,
69.5— 95.4 In lb f)
W 6 U 1 1 6 W A 9
4. If not as specified, replace the charcoal canister.
CANISTER DRAIN CUT VALVE (CDCV) INSPECTION
1. Remove the CDCV.
2. Inspect airflow between the ports of the CDCV.
O— - O : Continuity 0 = 0 : Airflow
Step
Term inal P ort
A B A B
1
r\
----
2
B+ GND
W 6 U 1 1 6 W A A
B A
W 6 U 1 1 6 W 0 7
M L I
n = a 3
&
* = i /
W 6 U 1 1 6 W A 8
3. If not as specified, replace the CDCV.
0 1 -1 6 -5