Mazda MX-6 1998, Руководство по ремонту

Страница: 834 / 1282

AUTOMATIC TRANSAXLE [LA4A-EL]
OIL SEALS REMOVAL/INSTALLATION [LA4A-EL]
1. Remove the drive shaft and joint shaft. (Refer to
0 5 -1 7A AUTOMATIC TRANSAXLE
REMOVAL/INSTALLATION [LA4A-EL].)
2. Remove the differential seals using the SSTs or
equivalent.
5. Install the drive shaft and joint shaft. (Refer to
0 5 -1 7A AUTOMATIC TRANSAXLE
REMOVAL/INSTALLATION [LA4A-EL].)
3. Apply a thin coat of petroleum jelly on the outside
and the lip of the new differential seals.
OIL PUMP BODY SEAL REMOVAL/INSTALLATION [LA4A-EL]
Issue
Some vehicles leak fluid from the pump-to-case
interface area of the transaxle. This may be caused
by the pump body seal being rolled or pinched during
installation.
Action
If a fluid leak is detected in the pump-to-case interface
area, refer to the following service procedure to
replace the pump body seal.
Caution
• This procedure does not require complete
teardown of the transaxle and should only
be used for leak concerns. If replacement
of the pump body or pump support is
required, the transaxle must be
disassembled and reassembled. The
components will be misaligned if this
repair is performed while the transaxle is
still in the vehicle.
1. Remove the transaxle. (Refer to 0 5 -1 7A
AUTOMATIC TRANSAXLE
REMOVAL/INSTALLATION [LA4A-EL].)
2. Remove the torque converter from the transaxle
and drain.
3. Remove the transaxle drain plug from the
transaxle case. Allow the transaxle to drain
completely.
W 6 U 5 1 7 W B W
4. Remove the pump drive shaft.
5. Position the transaxle with the pump facing up and
remove the TSS sensor mounting bolt.
W 6 U 5 1 7 W 1 0
4. Use the SST to tap in the differential seals.
ip
W 6 U 5 1 7 W B V
0 5 -1 7 A -2 9