Mazda MX-6 1998, Руководство по ремонту

Страница: 409 / 1282

MECHANICAL [FS]
Crankshaft Pulley Removal Note
• Hold the crankshaft by using the SST.
Caution
•
The crankshaft position sensor rotor is on
the rear of the crankshaft pulley, and can
be damaged easily.
Cylinder Head Cover Removal Note
• Loosen the cylinder head cover bolts in two or
three steps in the order shown.
Caution
•
The following will damage the belt and
shorten its life; forcefully twisting it,
turning it inside out, or allowing oil or
grease on it.
Note
• Mark the timing belt rotation on the belt for
proper reinstallation.
|(------ 4 FAULTY
25 mm {1.0 in} MIN.
. I W6U110WAL
W6U110WAH
No.3 Engine Mount Rubber Removal Note
1. Suspend the engine by using the chain block.
2. Remove the No.3 engine mount rubber.
Timing Belt Removal Note
1. Install the pulley lock bolt.
2. Turn the crankshaft clockwise and align the timing
marks.
Tensioner, Tensioner Spring Installation Note
1. Measure the tensioner spring free length. If not
within the specification, replace the tensioner
spring.
Free length
36.6 mm {1.44 in}
W6U110WAG
W6U110WAM
2. Install the tensioner.
Turn the tensioner clockwise by using an Allen
wrench.
Disconnect the tensioner spring from the hook pin.
W6U110WAJ
3.
4.
0 1 -1 OA-6