Mazda MX-6 1998, Руководство по ремонту

Страница: 1143 / 1282

GLASS/WINDOWS/MIRRORS
REAR DOOR GLASS AND GUIDE REMOVAL/INSTALLATION
1. Lower the rear door glass fully.
2. Remove the rear door screen. (Refer to 09-14
REAR DOOR LOCK AND OPENER
REMOVAL/INSTALLATION.)
3. Remove the rear beltline molding. (Refer to 09-16
REAR BELTLINE MOLDING
REMOVAL/INSTALLATION.)
4. Remove the screws, bolt and clip.
5. Remove the rear door glass guide.
BOLT
W 6 U 9 1 2 W 0 2
6. Raise the rear edge of the rear door glass about
90 mm {3.5 in} from the fully lowered position.
7. Remove the screws.
8. Remove the rear door glass.
9. Remove the glass run channel.
W 6 U 9 1 2 W A 2
10. Install in the reverse order of removal.
W 6 U 9 1 2 W A 1
FRONT POWER WINDOW REGULATOR INSPECTION
1. Disconnect the negative battery cable.
2. Remove the front door trim. (Refer to 09-17
FRONT DOOR TRIM
REMOVAL/INSTALLATION.)
3. Partially peel off the front door screen.
4. Disconnect the front power window regulator
connector.
5. Apply battery positive voltage to the front power
window regulator terminals and check the
operation of the front power window regulator.
C o n n e ctio n
R egulator
op e ra tio n
B+
GND
A
B Up
B
A Down
W 6 U 9 1 2 W 0 3
W 6 U 9 1 2 W A 3
6. If not as specified, replace the front power window
regulator.
FRONT POWER WINDOW REGULATOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable. 3. Disconnect the negative battery cable.
2. Remove the front door glass. (Refer to 09-12 4. Remove in the order indicated in the table.
FRONT DOOR GLASS AND GUIDE 5. Install in the reverse order of removal.
REMOVAL/INSTALLATION.)
0 9 -1 2 -2