Mazda MX-6 1998, Руководство по ремонту

Страница: 1150 / 1282

GLASS/WINDOWS/MIRRORS
REGULATOR HANDLE INSTALLATION
1. Install the clip In the regulator handle.
2. Set the door glass at the fully-raised position and
push the regulator handle on as shown.
W 6 U 9 1 2 W 1 4
45°
W6U912WAG
REAR WINDOW GLASS REMOVAL
Not Reusing Rear Window Glass
1. Disconnect the negative battery cable.
2. Remove the C-pillar trim. (Refer to 09-17
C-PILLAR TRIM REMOVAL/INSTALLATION.)
3. Remove the rear package trim. (Refer to 09-17
REAR PACKAGE TRIM
REMOVAL/INSTALLATION.)
4. Apply protective tape along the edge of the
headliner to protect it from damage.
5. Apply protective tape along the edge of the body
to protect it from damage.
Note
• The rear window molding is a replacement
part.
6. Remove the lip of the rear window molding by
using a razor knife.
PROTECTIVE TAPE
W 6 U 9 1 2 W 1 5
Note
• For the areas of the sealant that are difficult to
cut, use a piano wire and follow the
procedures under “ Reusing Rear Window
Glass”.
• There are clips installed in the areas indicated
in the figure.
CENTER
CLIP
SEC. A -A
W 6 U 9 1 2 W A J
7. Use a tool like that shown in the figure, and insert
the blade into the sealant.
8. Pull through the sealant around the edge of the
glass.
0 9 -1 2 -9