Mazda MX-6 1998, Руководство по ремонту

Страница: 614 / 1282

DRIVE SHAFT
Boot Band Disassembly Note Boot Disassembly Note
Note
• The boot band does not need to be removed
unless replacing it.
• Remove the boot clamp with end clamp pliers as
shown and discard the clamp.
Note
• The bell joint side boot does not need to be
removed unless replacing it or the bell joint
and shaft component.
• Do not strip the tape until the boot is assembled.
1. Wrap the shaft splines with tape.
2. Remove the boot.
W 6 U 3 1 3 W B 7
Outer Ring Disassembly Note
1. Mark the outer ring and the shaft for proper
assembly.
2. Remove the outer ring.
W 6 U 3 1 3 W B A
W 6 U 3 1 3 W B 8
Snap Ring, Tripod Joint Disassembly Note
1. Mark the shaft and tripod joint for proper
assembly.
2. Remove the snap ring by using snap-ring pliers.
3. Remove the tripod joint from the shaft.
ABS Sensor Rotor (With ABS) Assembly Note
Caution
•
Verify the direction of the sensor rotor.
• Set a new ABS sensor rotor on the drive shaft and
press it on by using the
SST.
MARKS
W 6 U 3 1 3 W B B
ABS Sensor Rotor (With ABS) Disassembly Note
Caution
•
Do not remove the sensor rotor unless it is
necessary.
• Do not reuse the sensor rotor if removed.
• Tap the ABS sensor rotor off the drive shaft by
using a chisel.
TAPE
MARKS
W 6 U 3 1 3 W B 9
0 3 -1 3 -1 2
W6U313WBC