Batch #
S E R I E S
SAAS Automotive PTY LTD
25 Metrolink Circuit West, Campbellfield,
Victoria 3061 Australia
ABN: 48166279670
ACN: 166279670
Phone: +61 3 9930 0100
Fax: +61 3 8339 2270
Email: [email protected]
Web: www.shopsaas.com
SINCE 1954
Page 4/4
SINCE 1954
Installation Instructions
FUEL LEVEL
Wiring Guide:
Wire colour
Wire Function
Wire Connection Location
Vehicle body
Ground 12V-
Black
Illumination 12V+ (
NOT
adjustable
) Park light circuit (do
NOT
connect to a dimmer)
Typical Layout
Wiring Diagram
Red
Ignition 12V+
Green
Fuel level input signal
Ignition harness / fuse box
Fuel sender
Ground 12V-
Ignition 12V+
Illumination 12V+
Connector pinout
Fuel level signal 12V-
Important notes before installing:
-
Installing this product to your vehicle may require an adaptor. SAAS make a large range of
adaptors and installation parts, please check with your SAAS dealer for available adaptors.
-
SAAS Streetline series gauges are designed for
12 volt
systems
ONLY!
-
All installation work should be done by a qualified professional to avoid damage to this product.
-
SAAS
RECOMMENDS
all products be tested prior to installation. This will save time and speed up
the troubleshooting process if you encounter any issues.
- BEFORE
installing, please check our website (
shopsaas.com
) for the latest fitting instructions.
If the top left corner (
v
) number is different to website, please use instructions from website.
Yellow
Part No: SG21290
2 inch-52mm
Mounting studs for U bracket.
Fitting U bracket
: Fit supplied
stud spacers to threads before
using the supplied U bracket.
Rear of gauge
Warranty Terms & Conditions:
SAAS Automotive Pty Ltd warrants this product against defects in factory workmanship and
materials for a period of twelve (
12
) months from the date of original purchase. This warranty
applies to the first retail purchaser, is non-transferable and covers only where the product has
been subjected to normal use or service. Provision of this warranty shall not apply to any SAAS
Automotive product that has been used for a purpose for which it is not designed, or which has
been altered in any way that would be detrimental to the performance or life of the product, or
misapplication, misuse, negligence or accident. Warranty claims to the manufacturer must be
transportation prepaid and accompanied with dated proof of purchase. On any part or product
found to be defective after examination by SAAS Automotive Pty Ltd, SAAS Automotive Pty Ltd will
only repair or replace the merchandise through the original selling dealer or on a direct basis.
SAAS Automotive Pty Ltd assumes no responsibility for diagnosis, removal and/or installation
labour, loss of vehicle use, loss of time, inconvenience or any other consequential expenses. The
warranties herein are in lieu of any other expressed or implied warranties, including any implied
warranty of suitability, and any other obligation on the part of SAAS Automotive Pty Ltd, or the
selling dealer.
For further assistance email: [email protected]
Page 1/4
Note:
Colour change button
is on the front of gauge.
v20210913
Sender preset button
(Use to set sender
Ω
range)
