Mazda MX-6 1998, Руководство по ремонту, Страница: 643 / 1282

CONVENTIONAL BRAKE SYSTEM
W 6 U 4 1 1 W A 0
6. Repeat step 4 and 5 until no air bubbles are seen.
The reservoir should be kept about 3/4 full during
bleeding to prevent air from reentering the lines.
Tightening torque
5.9— 8.8 N m {60— 90 kgfcm , 53— 78 in lbf}
7. Inspect for correct brake operation.
8. Verify that there is no fluid leakage. Wipe off any
spilled fluid immediately.
9. After bleeding the brakes, add brake fluid to the
maximum level.
BRAKE FLUID
Brake Fluid Inspection
1. Depress the brake pedal several times, and
inspect for leakage of the brake line system.
2. Verify that the fluid level in the reservoir Is
between the MAX and MIN lines on the reservoir.
3. If the fluid level is extremely low, inspect the brake
system for leakage.
Fluid specification
SAE J1703 or FMVSS116 DOT-3
W 6 U 4 1 1 W 2 4
1. Remove the brake fluid from the reservoir by
using a suction pump.
2. Fill the reservoir with clean brake fluid.
3. Attach a vinyl tube to the farthest bleeder screw
and place the other end of the tube in a clear
container.
4. Remove all old brake fluid from the brake lines by
loosening the bleeder screw and pumping the
brake pedal until only clean fluid is seen. The
reservoir should be kept about 3/4 full during
bleeding to prevent air from reentering the lines.
4 9 0 2 5 9 7 7 0 B
W 6 U 4 1 1 W 8 L W 6 U 4 1 1 W B M
Brake Fluid Replacement
5. Perform the above for all bleeder screws.
6. Fill the reservoir to the specified levels.
Caution
•
Brake fluid will damage painted surfaces.
If brake fluid does get on a painted
surface, wipe it off immediately.
BRAKE PIPE INSPECTION
Brake Pipe inspection
• Inspect for cracks, damage, and corrosion of the
brake pipe. Replace the pipe or flare nut(s) as
necessary.
W 6 U 4 1 1 W 2 5
£ H
I
W6U411WBN
0 4 -1 1 -2