Mazda MX-6 1998, Руководство по ремонту, Страница: 534 / 1282

CONTROL SYSTEM [FS]
(2) Turn the ignition switch to ON.
(3) Select the “ PID/DATA MONITOR AND
RECORD” function on the NGS tester display
and press TRIGGER.
(4) Select “CPP/PNP" on the NGS tester display
and press START. The NGS tester measures
and shows the operation.
Specification
Condition
“CPP/PNP” operation
Other than neutral position
and clutch pedal released
OFF
Neutral position or clutch
pedal depressed
ON
(5) If not as specified, check the related harness
and clutch switch continuity.
(6) If okay, check the neutral switch.
Inspection of Continuity
1. Disconnect the clutch switch connector.
2. Check continuity of the clutch switch by using an
ohmmeter.
A
\
8
I
E
c
D
¿ z m rh
W 6 U 1 4 0 W B A
Q Q : Continuity
Condition
Terminal
c
E
Clutch pedal depressed
O ---------- --------- O
Clutch pedal released
W 6 U 1 4 0 W B B
3. If not as specified, replace the clutch switch.
CLUTCH SWITCH REMOVAL/INSTALLATION [FS]
1. Disconnect the battery negative cable.
2. Disconnect the clutch switch connector.
3. Remove the clutch switch.
4. Install the clutch switch as shown in the figure.
W 6 U 1 4 0 W 2 1
^ ®
__
'CLUTCH SWITCH
w s u u o w b c
0 1 -4 0 A -2 9