Mazda MX-6 1998, Руководство по ремонту, Страница: 927 / 1282

BASIC SYSTEM
AIRFLOW MODE MAIN LINK REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the airflow mode actuator.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
W 6 U 7 1 1 W A 7
1 Screw
2 Airflow mode main link
tr Installation Note
Airflow Mode Main Link Installation Note
Caution
•
If any grease other than the specified
grease is applied to the links, abnormal
noise will occur or the links will not
properly operate. Therefore, do not apply
any grease to the links.
1. Push and hold each airflow mode sub link in the
direction of the arrow.
3. Press the airflow mode main link lightly and rotate
it in the direction of the arrow, then set the
projections of each airflow mode sub link into the
grooves of the airflow mode main link.
4. Rotate airflow mode main link and verify that each
mode is accessed properly.
AIRFLOW MODE
SUB LINK
W 6 U 7 1 1 W A 8
HEATER CORE INSPECTION
1. Remove the heater core from the heater unit.
(Refer to 07-11 HEATER UNIT
DISASSEMBLY/ASSEMBLY.)
2. Check for cracks, damage, and coolant leakage. If
any are found, replace the heater core.
W6U711W10
3. Check for bent fins. If any are bent, use a flathead
screwdriver to straighten them.
4. Verify that the heater core inlet and outlet are not
distorted or damaged. Repair with pliers if
necessary.
W 6 U 7 1 1 W A H
W6U711W09
Set the airflow mode main link to the heater unit
as shown in the figure.
AIRFLOW MODE
MAIN LINK
AIRFLOW MODE
MAIN LINK
0 7 -1 1 -7