Mazda MX-6 1998, Руководство по ремонту

Страница: 1011 / 1282

TROUBLESHOOTING [POWER DOOR LOCK SYSTEM]
STEP
INSPECTION
ACTION
12 Make sure that driver’s side door is opened.
Connect keyless unit connector.
Connect volt-meter between keyless
connector terminal E and ground.
Perform following procedures
within 30
seconds:
0 Repeat following five times:
• Turn ignition switch to ON.
• Turn ignition switch to LOCK.
© Remove ignition key from steering lock.
(3) Repeat following three times:
• Push driver’s side door switch.
• Release driver’s side door switch.
M easure voltage at keyless unit connector
terminal E.
• 5 V (during performing the above
procedures) -> 0 V (until on-board
diagnostic activate verification buzzer
sounds)
Is voltage 0 V?
W 6 U 9 0 1 W E 7
Yes Go to next step.
No Visually check for bents or other damage to keyless unit
connector terminals.
Check for open or short circuit between keyless unit
terminal E and CPU connector terminal 2 0 .
13 Attempt to activate on-board diagnostic
function 1 or 2 again.
Does on-board diagnostic function 1 or 2
activate?
Yes On-board diagnostic is operative now.
No
Replace keyless unit.
0 9 -0 1 E -1 3