Mazda MX-6 1998, Руководство по ремонту

Страница: 545 / 1282

CONTROL SYSTEM [KL]
Note
• The “PID/DATA MONITOR AND RECORD”
function is to monitor the calculation value of
input/output signals in the PCM. Deviation in
the value does not always indicate malfunction
in the related input/output devices.
• For inspection of the input/output signals other
than in the link monitor table, check voltage at
the applicable PCM terminal by using the
SST
(104 Pin Breakout Box).
3. Press CLEAR to clear previously selected items.
(A list of item descriptions appears on the screen).
4. Select items necessary and press START.
5. Carry out inspection referring to PID/DATA
MONITOR table.
6. If normal output signal cannot be detected when
all input signals are normal, replace the PCM.
(Refer to 01-40B POWERTRAIN CONTROL
MODULE (PCM) REMOVAL/INSTALLATION
[KL].)
PID/DATA MONITOR item table
Note
• The following PIDs may display on the NGS tester, but these are not used for inspection, because of
these device are not applied for this model.
• ACP • EGRVF
• HTR22A
• PTO
• AIRA
•
EGRVR
• HTRX1 • TAR LRN
• AIRF
•
EVAPCP • HTRX2 • TATCF
• AIRM
•
EVAPVMA
• IMRC • TCCA
• ARCF
•
FANM • IMRCF
• TCCMACT
• CCS
•
FFFM
• IMTVF
• TRAC
• DPFEGR
•
F P M • INJ7F
• TRANRAT
• EGRC
•
FTP B
• INJ8F • TRD
• EGRCF •
HFCA • K S V
• WACA
• EGRFO
•
HTR11A
• LFCA • WACF
• EGRFS
•
HTR12A
• LFPF • 4 x 4L
• EGRV
•
HTR21A • OCTADJ
M o n ito r item
Full name U n it/C o n d itio n
A p p lic a tio n
MTX ATX
ACCS
A/C switch ON/OFF
X X
ACP V Refrigerant pressure switch signal voltage
V
X
X
BARO Barometric pressure
Hz
X X
BLWMTR Fan switch ON/OFF
X X
BOO Brake switch
ON/OFF
X
CPP/PNP Neutral/Clutch switch
ON/OFF
X
DRIVECT
Total number of OBD II drive mode completed —
X X
DRLMP Daytime running lights (for CANADA) ON/OFF
X X
DTC CNT
Total number of diagnostic trouble codes (DTC) stored in
PCM (Include pending codes)
—
X X
ECT Engine coolant temperature ° C /” F
X X
ECT V Engine coolant temperature sensor signal voltage
V
X X
EGR Barometric pressure or EGR pressure PSI
X X
EGRBARO EGR
boost solenoid valve
ON/OFF
X X
EGRCD1
EGR valve (Coil #1) ON/OFF
X X
EGRCD2
EGR valve (Coil #2) ON/OFF
X X
Using the SST (NGS Tester)
1. In the passenger compartment, connect the SSTs
(NGS tester) to the data link connector.
BATTERY
W 6 U 1 4 0 W M 3
2. Referring to the NGS tester instruction manual,
select the “PID/DATA MONITOR AND RECORD”
and press TRIGGER.
0 1 -4 0 B -1 0