Mazda MX-6 1998, Руководство по ремонту

Страница: 852 / 1282

AUTOMATIC TRANSAXLE [GF4A-EL]
TRANSAXLE RANGE SWITCH REMOVAL/INSTALLATION [GF4A-EL]
1. Disconnect the negative battery cable.
2. Remove the resonance chamber, fresh-air duct,
and air cleaner component. (Refer to 0 1 -1 3B
INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION [KL].)
3. Disconnect the transaxle range switch connector.
4. Remove the clip and spring pin.
5. Remove the selector cable in the order shown in
the figure.
(1) Disconnect the selector cable from the manual
shaft lever.
(2) Pull out the selector cable from the cable
bracket and remove it.
W 6 U 5 1 7 W 1 9
13. Tighten the transaxle range switch mounting bolts.
Tightening torque
7.9— 10.7 N m
{80— 110 kgf-cm, 69.5— 95.4 in ibì}
14. Install the lever and spring washer.
15. Tighten the manual shaft nut by using a torque
wrench.
Tightening torque
32— 46 N m {3.2—4.7 kgf-m, 24— 33 ft lbf}
6. Remove the manual shaft nut.
7. Remove the lock-washer and lever.
8. Remove the transaxle range switch.
9. Rotate the manual shaft to converter housing side
fully, then return 2 notches to set the neutral
position.
10. Turn the transaxle range switch so that the N
mark is in line with the flat, straight surfaces on
either side of the manual shaft.
W 6 U 5 1 7 W D 5
11. Hand tighten the transaxle range switch bolts.
12. Verify that there is continuity between terminals A
and H of the transaxle range switch connector.
W 6 U 5 1 7 W D 7
16. Verify that the selector lever range position and
transaxle range switch are aligned; then connect
the selector cable and install a new spring pin and
clip.
17. Check continuity of the transaxle range switch.
(Refer to
0 5 - 1 7B
TRANSAXLE RANGE SWITCH
INSPECTION [GF4A-EL], Inspection of
Continuity.)
18. C o n n e c t th e tra n s a x le ra n g e s w itc h c o n n e c to r.
19. Install the air cleaner component, fresh-air duct,
and resonance chamber. (Refer to
0 1 - 1 3B
INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION [KL].)
20. Connect the negative battery cable.
21.
Check operation of the transaxle range switch.
(Refer to
0 5 - 1 7B
TRANSAXLE RANGE SWITCH
INSPECTION [GF4A-EL], Inspection of
Operation.)
0 5 -1 7 B -1 2