DRIVE SHAFT
Clearance B
2.4— 2.8 mm {0.095— 0.110 in}
W6U313WBJ
If clearance B is more than the specification,
reduce clearance A of the
SST
and crimp the boot
again.
If clearance B is less than the specification,
replace the boot band, increase clearance A of the
SST,
and crimp the new boot.
3. Verify that the boot band does not protrude from
the boot band installation area. If it does, replace
the boot band and repeat step 2.
4. Fill the boot with the repair kit grease.
5. Adjust clearance A by turning the adjusting bolt of
the
SST.
Clearance A
3.2 mm {0.13 in}
6. Crimp the wheel side big boot band by using the
SST.
Verify that clearance B is within the
specification.
Clearance B
2.4— 2.8 mm {0.095— 0.110 in}
If clearance B is more than the specification,
reduce clearance A of the
SST
and crimp the boot
again.
If clearance B is less than the specification,
replace the boot band, increase clearance A of the
SST
and crimp the new boot.
7. Verify that the boot band does not protrude from
the boot band installation area. If it does, replace
the boot band and repeat step 6.
0 3 -1 3 -1 4
Содержание MX-6 1998
