Mazda MX-6 1998, Руководство по ремонту

Страница: 565 / 1282

CONTROL SYSTEM [KL]
In s p e c tio n o f C o n tin u ity
1. Disconnect the neutral switch connector.
2. Check continuity of the switch by using an
ohmmeter.
: Continuity
Condition
Terminal
A
B
N e u tra l
o
------------ ------------
O
O th e r
W 6 U 1 4 0 W N 5
3. If not as specified, replace the neutral switch.
W6U140WN4
NEUTRAL SWITCH REMOVAL/INSTALLATION [KL]
1. Disconnect the battery negative cable.
2. Disconnect the neutral switch connector.
3. Remove the neutral switch.
4. Install the reverse order of removal.
Tightening torque
20— 29 N m {2.0— 3.0 kg fm , 15— 21 ft ibf}
W6U140W0U
D R IV E S H A F T
W6U140WN6
CLUTCH SWITCH INSPECTION [KL]
Inspection of Output Voltage
1. If the SST (104 Pin Breakout Box) are used,
check in the following order.
(1) Remove the PCM. (Refer to 01-40B
POWERTRAIN CONTROL MODULE (PCM)
REMOVAL/INSTALLATION [KL].)
Connect the SST (104 Pin Breakout Box) to
the PCM as shown.
(
2
)
W6U140WN7
(3) Tighten the connector bolt.
T ig h te n in g to rq u e
7 .9 — 1 0 .7 N-m
{8 0 — 1 0 0 k g f cm , 6 9 .5 — 9 5 .4 in lbf}
(4) Turn the ignition switch to ON.
(5) Measure the voltage at PCM terminal 64.
W6U140W0V
Specification
Condition
PCM terminal 64
voltage (V)
Other than neutral position
and clutch pedal released
B+
Neutral position or clutch
pedal depressed
Below 1.0
(6) If not as specified, check the related harness
and clutch switch continuity.
(7) If okay, check the neutral switch.
2. If the
S STs
(NGS tester) are used, check in the
following order.
(1) Connect the
SSTs (NGS tester) to the data
link connector.
B A T TE R Y
W 6 U 1 40 W N P
(2) Turn the ignition switch to ON.
0 1 -4 0 B -3 0
DR IV E
S H A F T