Mazda MX-6 1998, Руководство по ремонту, Страница: 813 / 1282

AUTOMATIC TRANSAXLE [LA4A-EL]
A TF L e v e l In s p e c tio n
Caution
•
The ATF amount varies according to ATF’s
temperature. Therefore, when checking the
ATF level or replacing the ATF, use a
thermometer to measure the temperature
then adjust the ATF amount to the
specified level according to the specified
temperature.
1. Park the vehicle on level ground.
2. Apply the parking brake and position wheel
chocks securely to prevent the vehicle from
rolling.
C a u tio n
•
Do n o t w a rm th e tra n s a x le by p e rfo rm in g
s ta lls . T h is w ill d a m a g e th e to rq u e
converter.
5. While depressing the brake pedal, shift the
selector lever to each range (P— 1), pausing
momentarily in each range.
6. Shift back to P position.
N ote
• If the ATF level is too high or too low in hot
condition, the following problems may be the
cause.
ATF
le vel C o n d itio n P o s s ib le c a u s e
Too low
Line pressure is
lower than the
specification
Air in transaxle oil passage
due to slipping or damaged
clutch mechanism
Too high ATF is hot
ATF deteriorated due to
slipping clutch or stuck
valve
WHEEL CHOCK
W6U517WCW
7. Ensure that the ATF level is between max. and
min.
3. Adjust the length of the thermistor probe measure
to the same length as the dipstick and hold the
probe with a paper holder. Insert into the filler tube
and measure the temperature.
W6U517WA3
4. Warm up the engine until the ATF reaches 66— 77
°C {150— 170 “ F}.
DO NOT DRIVE MARK
MIN. MAX.
I |o D O N 'T A O O IN T H IS A R E A
V
FLUID LEVEL AT NORMAL OPERATING
TEMPERATURE
6 6 - 7 7 X {1 5 0 -1 7 0 *F}
W 6 U S 1 7 W A 4
ATF type
ATF M-II1 or equivalent (e.g. Mercon®)
AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT
Warning
• When the transaxle and ATF art hot, they
can badly burn. Turn off the engine and
wait until they are cool before changing
the ATF.
1. Remove the dipstick.
2. Remove the drain plug.
3. Clear the sealant dust from the bolt hole.
4. Install a drain plug.
Tightening torque
15— 35 N m {1.5— 3.6 kgf-m, 11— 26 ft lbf}
[LA4A-EL]
W6U517W04
5. Add the specified amount and type of ATF through
the oil filler tube.
ATF type
ATF M-lll or equivalent (e.g. Mercon®)
Capacity
8.3 L {8.8 US qt, 7.3 Imp qt}
6. Install the dipstick.
7. Verify the ATF level. (Refer to 0 5 -1 7A
AUTOMATIC TRANSAXLE FLUID (ATF)
INSPECTION [LA4A-EL], ATF Level Inspection.)
0 5 -1 7 A -8