Mazda MX-6 1998, Руководство по ремонту

Страница: 924 / 1282

BASIC SYSTEM
COOLING UNIT REMOVAL/INSTALLATION
1. Discharge the refrigerant from the system.
2. Remove the center lower panel. (Refer to 09-17
CENTER LOWER PANEL
REMOVAL/INSTALLATION.)
Caution
•
If moisture or foreign material enters the
refrigeration cycle, cooling ability will be
lowered and abnormal noise will occur.
Always immediately plug all open fittings
after removing any refrigeration cycle
parts to keep moisture or foreign material
out of the cycle.
3. Disconnect the accumulator tank. (Refer to 07-11
ACCUMULATOR TANK
REMOVAL/INSTALLATION.)
4. Disconnect cooler pipe No.5. (Refer to 07-11
REFRIGERANT LINES
REMOVAL/INSTALLATION.)
5. Remove in the order indicated in the table. Do not
allow compressor oil to spill.
6. Install in the reverse order of removal.
7. Recharge with refrigerant. (Refer to 07-10
REFRIGERANT CHARGING.)
8. Perform the refrigerant system performance test.
(Refer to 07-10 REFRIGERANT SYSTEM
PERFORMANCE TEST.)
W 6 U 7 1 1 W 0 4
Nut
Cooling unit
i t
Installation Note
Cooling Unit Installation Note
• When installing a new cooling unit (evaporator),
add SP-20 compressor oil into the refrigeration
cycle.
Supplemental amount
50 ml (50 cc, 1.7 fl oz}
0 7 -1 1 -4