Mazda MX-6 1998, Руководство по ремонту

Страница: 496 / 1282

IGNITION SYSTEM
IGNITION COIL
REMOVAL/INSTALLATION ....................01-18-1
IGNITION COIL IN S P E C T IO N .................. 01-18-1
Primary Coil Winding ............................. 0 1-18-1
Secondary Coil Winding ........................ 0 1 -1 8 -2
01-18 IGNITION SYSTEM
Insulation Resistance of Case .............. 0 1 -1 8 -2
HIGH-TENSION LEAD
REMOVAL/INSTALLATION.................... 0 1 -1 8 -3
SPARK PLUG INSPECTION [K L ] 0 1 -1 8 -3
IGNITION COIL REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the fresh-air duct. (FS) (Refer to 01-13A
INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION [FS].)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
W 6 U 1 1 8 W 0 1
FS
7.9— 10.7 N m {80— 110 kgf cm, 69.5—95.4 In lb f}
W 6 U 1 1 8 W A 0
1 High-tension lead
o - 0 1 -1 8 HIGH-TENSION LEAD
REMOVAL/INSTALLATION
2 Connector
3 Condenser
4 Ignition coil
5 Ignition coil bracket
IGNITION COIL INSPECTION
W 6 U 1 1 8 W 0 2
Primary Coil Winding
1. Disconnect the ignition coil connector.
2. Measure the resistance by using an ohmmeter.
• From terminal A to B, and terminal B to C.
(FS)
• From terminal A to D, and terminal B to D, and
terminal C to D. (KL)
Specification
0.45— 0.55 ft [20 °C {6 8 °F}]
N.m {k g fm , ttlb f }
W 6 U 1 1 8 W A 1
19—25 {1.9— 2.6,14— 18}
N m
{49—70 kgf cm,
43—60 In-lbf}
{80— 110 k g fc m ,
69.5— 95.4 in lb f}
0 1 -1 8 -1