Mazda MX-6 1998, Руководство по ремонту, Страница: 1133 / 1282

BODY PANELS
1 Fastener
2
Hood insulator
3 Parting seal weatherstrip
4 Shroud seal weatherstrip
5 Bolt A
6 Hood
7
Bolt B
8 Hood hinge
9 Nut
10 Hood stay
T R U N K L ID A D J U S T M E N T
G a p a n d H e ig h t
1. Remove the trunk lid striker.
2. Measure the gap and height between the trunk lid
and the body.
Clearance
Standard
(mm {in})
Minimum
(mm {in})
Maximum
(mm {in})
a 4.4 (0.17)
3.4(0.14} 5.4 (0.21}
b -0 .6 {-0.02}
-1 .6 (-0.06} 0.4 {0.01}
c 8.1 {0.32} 6.6 (0.26} 9.6 {0.37}
W 6 U 9 1 0 W 0 5
O : Position
Tension
Hook
bracket
Set position
a b
Standard
Right side
o
Left side
O
Increase
Right side
o
Left side
o
Decrease
Right side
0
Left side
o
W 6 U 9 1 0 W A 6
3. Hand-tighten the trunk lid striker installation bolts.
4. If not as specified, loosen the trunk lid hinge
installation nuts and the trunk lid striker installation
bolts, and reposition the trunk lid.
5. Tighten the bolts and nuts.
6. Adjust the trunk lid striker. (Refer to 09-14
TRUNK LID STRIKER ADJUSTMENT.)
RIGHT SIDE
HOOK BRACKET
W 6 U 9 1 0 W A 7
LEFT SIDE
T e n s io n
N o te
• The trunk lid should raise
7 0 — 3 0 0 m m
(2 .8 — 11.8 in }
when the trunk lid is unlocked.
Slide the balance spring to the desired position as
described below by using a tape-wrapped
screwdriver.
H O O K
BRACKET
B A L A N C E
S P R IN G
W 6 U 9 1 0 W A 8
0 9 -1 0 -3