Mazda MX-6 1998, Руководство по ремонту

Страница: 667 / 1282

ANTILOCK BRAKE SYSTEM
W 6 U 4 1 3 W A 2
4. Secure the HU as shown.
5. Remove the bolts.
6. Protect the HU from damage to the valve body
and keep the sealing surface free from foreign
materials.
ABS Control Module Installation Note
1. Verify that the sealing surface of the HU is clean.
If there are scratches, grooves or dirt, do not
mechanically rework. Carefully remove any dirt or
seal residue with plastic tools only. The use of
chemical solvents is not permitted.
2. Install the spring plate properly. When
re-installing, insert the spring plate over the valve
bodies in the correct position to preload the spring
and to center the solenoid coils.
SPRING PLATE
u
jfc=p
p m
1
3. Carefully fit the coils of the ABS CM over the
valve bodies.
4. Locate the ABS CM by placing the new bolts
evenly against the housing and tightening them
slightly by hands. To aid alignment, the housing
may be pressed onto the contact surface by hand
while tightening the bolts.
5. Tighten the bolts to the specified torque in the
order shown.
Tightening torque
2.4— 2.8 N-m {24— 28 kgf-cm, 21— 24 in-lbf}
W 6 U 4 1 3 W A 5
6. Visually inspect for all bolts mode contact. The
ABS CM must be flush against the housing with
no gap in the area of the bolts.
7. Connect the 2-pin connector of the pump motor to
the ABS CM. Verify that the spring clip is engaged
securely.
8. Clip the wiring back in the cable guide.
9. Reinsert the soft mount if it is fallen out.
10. Inspect flats of two side retaining bolts and
position flats vertically by turning bolts as
necessary.
W 6 U 4 1 3 W A 4
VISE
W 6 U 4 1 3 W A 3
0 4 -1 3 -3