Mazda MX-6 1998, Руководство по ремонту

Страница: 666 / 1282

ANTILOCK BRAKE SYSTEM
ABS HYDRAULIC UNIT AND CONTROL MODULE REMOVAL/INSTALLATION
W 6 U 4 1 3 W 0 2
1. Remove the charcoal canister.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Note
• The ABS hydraulic unit is not purchased as one part. Replace the ABS hydraulic unit and control module
component as one assembly part if the ABS hydraulic unit is malfunctioning.
1 Brake pipe
2 Connector
3 ABS hydraulic unit and ABS control module
o - Removal/Installation Note
4 ABS control module
it
Removal Note
w Installation Note
5
ABS hydraulic unit
6 Spring plate
7 Stud
8 Soft mount
ABS Hydraulic Unit and ABS Control Module
Removal/Installation Note
• When removing/installing the ABS hydraulic unit
and ABS control module from/to the vehicle,
attach protective tape on the HU connector to
prevent brake fluid from entering.
ABS Control Module Removal Note
1. Install the screw plugs (supplied in the service part
kit) onto the brake pipe holes of the HU.
2. Disconnect the motor connector as follows.
Caution
•
Do not apply force on the looking tab
when disconnecting the connector.
(1) Lift up the tab to unlock the connector by
hand.
(2) Pull the connector from the ABS CM by
grasping the side of the motor connector.
3. Carefully pull the wiring of the pump motor out of
the cable guides.
0 4 -1 3 -2