Mazda MX-6 1998, Руководство по ремонту

Страница: 831 / 1282

AUTOMATIC TRANSAXLE [LA4A-EL]
2. To install the engine mount member, put the No.2
engine mount stud bolts through the engine mount
member installation holes.
3. Install the engine mount member bolts A and nuts
A.
Tightening torque
A: 67— 93 N m {6.8— 9.5 kgf-m, 50—68 ftlb f}
4. Loosely tighten the No.2 engine mount nuts B.
5. Remove the SST (engine support).
6. Tighten the No.2 engine mount nuts B.
Tightening torque
B: 75— 104 N m {7.6— 10.7 kgf-m, 55— 77 ft lbf}
2/4 BAND SERVO REMOVAL/INSTALLATION
Caution
•
Servicing the 2/4 band servo in the vehicle
is only recommended in the event of a
leak, if servicing is required due to a servo
problem, it is necessary to remove and
disassemble the transaxle to inspect the
2/4 band component and direct clutch for
damage.
1. Raise and support the vehicle.
2. Remove the splash shield.
Warning
•
The servo cover is under high spring
pressure.
3. Install a nut with an integral washer onto the
forcing bolt of the servo cover remover/replacer
tool with a permanent thread sealer. This nut and
washer will aid in the installation of the cover.
W 6 U 5 1 7 W 0 8
5. Remove the servo cover retaining ring and
release the tension on the servo cover component
slowly.
6. After releasing all of the tension on the servo
cover component, remove the SST.
7. Remove the servo cover component, 2/4 servo
piston and return spring.
8. Lubricate the 2/4 servo piston, servo cover, servo
cover seal, and servo case bore using ATF or
petroleum jelly to aid in the installation and
prevent cutting of the seal.
Install the 2/4 servo piston and return spring into
the transaxle case.
Install the SST.
Tighten the center screw to compress the 2/4
servo into the bore.
Note
• If the cover will not seat deep enough in the
bore to install the servo cover retaining ring, a
blunt punch may be used with a small
hammer. Gently tap the cover around the
outer edge with the punch until the snap ring
groove is fully exposed.
12. Install the servo cover retaining ring into transaxle
case.
13. Remove the SST.
14. Lower the vehicle. Check the fluid level prior to
road testing.
10.
11
.
W 6 U 5 1 7 W B J
4. Install the SST and compress the servo cover
component.
0 5 -1 7 A -2 6