Mazda MX-6 1998, Руководство по ремонту

Страница: 890 / 1282

ENGINE SPEED SENSING POWER STEERING
Tie-rod End Ball Joint Removal Note
1. Remove the tie rod nut.
2. Separate the tie-rod end from the steering knuckle
by using the SSTs.
W 6 U 6 1 2 W A F
No.1 Engine Mount Component Removal Note
Caution
•
To prevent damage to the body, insert a
rag into the gap between the fender and
body, when installing the SST.
1 . Set the SSTs as shown in the figure.
2. Remove the engine mount.
W 6 U 6 1 2 W A G
Steering Gear And Linkage Removal Note
• Remove the steering gear and linkage by pulling it
from the right side.
Mounting Bracket Nut And Bolt Installation Note
1. Loosely tighten nuts 4 and 3.
2. Tighten the mounting bracket nuts and bolts to the
specified torque in the order shown.
Bolt (Intermediate Shaft) Installation Note
• Align the marks and install the intermediate shaft
and bolt.
W 6 U 6 1 2 W A J
Pressure Pipe Installation Note
1. Hand-tighten the pressure pipe fitting to the gear
housing, being careful not to damage the O-ring.
2. Hand-tighten bolt A.
3. Tighten bolt B to the specified torque.
Tightening torque
7.9— 10.7 N m (80— 110 kgf cm, 70— 95 in lbf}
4. Tighten bolt A and the pressure pipe fitting to the
specified torque.
Tightening Torque
35— 44 N m (3.5— 4.5 kgf-m, 26— 32 ft lbf}
0 6 -1 2 -8