Mazda MX-6 1998, Руководство по ремонту

Страница: 1207 / 1282

EXTERIOR TRIM
ROOF MOLDING REMOVAL
W 6 U 9 1 6 W 1 5
• Pull up each end of roof molding to remove it.
Note
• The roof molding is installed with double-sided
adhesive tape. If the roof molding is difficult to
remove, soften the double-sided adhesive
tape by using a hot air blower.
ROOF MOLDING INSTALLATION
Note
• The roof molding is a replacement part.
1. Remove the adhesive remaining on the body by
using a razor knife.
2. Remove any grease or dirt from the adhesion
surface of the body.
3. Apply repair sealant as shown.
1040— 1080 {40.95—42.51}
690— 730 {27.2— 28.7}
’350—390(13.8— 15.3}"'
35 {1.4}
VEHICLE
FORWARD
35 {1.4}
30{1.2} 20(0.8}
APPLY SEALANT IN
MODERATE IN THIS
AREA
m m {in }
W 6 U 9 1 6 W A M
W 6 U 9 1 6 W 1 6
5. Peel off the wax paper from the double-sided
adhesive tape.
6. Align the rear end of the roof molding with the rear
end of the roof molding groove. (1)
7. Install the roof molding, starting from rear and
moving forward. (2)
■*— VEHICLE FORWARD
ROOF MOLDING
ROOF MOLDING GROOVE
W 6 U 9 1 6 W A K
4. Attach double-sided adhesive tape to the roof
molding as shown.
1.2(0.05}
m m {In }
W 6 U 9 1 6 W A J
0 9 -1 6 -6