Mazda MX-6 1998, Руководство по ремонту

Страница: 672 / 1282

TRACTION CONTROL SYSTEM (TCS)
04-14 TRACTION CONTROL SYSTEM (TCS)
TCS OPERATION IN S P E C T IO N .............. 04-14-1
ABS/TCS CONTROL MODULE
REM OVAL/INSTALLATION....................04-14-1
ABS/TCS HARNESS AND INPUT SIGNAL
IN S P E C TIO N ............................................. 04-14-1
TCS OFF SWITCH
REM OVAL/INSTALLATION.................... 04 -1 4 -1
TCS OFF SWITCH INSPECTION ............ 0 4 -1 4 -2
T C S O P E R A T IO N IN S P E C T IO N
1. Place the front wheels on a chassis roller or jack
up the front of the vehicle on level ground and
support it on safety stands.
2. Start the engine, and verify that the TCS OFF light
is out.
Note
• In order to protect the engine, if engine
coolant temperature is extremely low, TCS
control is temporarily interrupted until the
engine coolant temperature rises. In such
cases, the TCS OFF light illuminates.
3. If the light stays on after the engine is started and
reaches normal operating temperature, the
ABS/TCS control module detects a failure. In that
case, turn off the engine and follow the
troubleshooting procedures.
W 6 U 4 1 4 W 0 1
4. Shift the transaxle to second (MTX) or D range
(ATX).
5. Depress the accelerater pedal for 5 seconds, and
verify that the engine speed is held low and the
TCS indicator light is flashing.
Note
• If the front wheels rotate for 60 seconds or
more, the ABS warning light, TCS indicator
light and TCS OFF lights illuminate, and the
engine speed increases. In that case, turn the
ignition switch to OFF and ON again, then
drive the vehicle faster than
10 km/h {6.2
mph}. Verify that those lights go out.
ABS/TCS CM does not memorize DTC.
6. If not as described, follow the troubleshooting
procedures.
ABS/TCS CONTROL MODULE REMOVAL/INSTALLATION
(Refer to 04 -1 3 ABS HYDRAULIC UNIT AND
CONTROL MODULE REMOVAL/INSTALLATION.)
ABS/TCS HARNESS AND INPUT SIGNAL INSPECTION
(R eferto 04 -1 3 ABS HARNESS AND INPUT
SIGNAL INSPECTION.)
TCS OFF SWITCH REMOVAL/INSTALLATION
1. Remove the meter hood. (Refer to 09-17 METER
HOOD REMOVAL/INSTALLATION.)
2. Press the hooks of the TCS OFF switch and pull
the switch out.
3. Install in the reverse order of removal.
0 4 -1 4 -1