Mazda MX-6 1998, Руководство по ремонту

Страница: 533 / 1282

CONTROL SYSTEM [FS]
Inspection of Continuity
1. Disconnect the neutral switch connector.
2. Check continuity of the switch by using an
ohmmeter.
: Continuity
C o n d itio n
Term inal
A
B
Neutral
O------------ ------------O
Other
W 6 U 1 4 0 W 8 7
3. If not as specified, replace the neutral switch.
W 6 U 1 4 0 W B 6
NEUTRAL SWITCH REMOVAL/INSTALLATION [FS]
1. Disconnect the battery negative cable.
2. Disconnect the neutral switch connector.
3. Remove the neutral switch.
4. Install the reverse order of removal.
Tightening torque
20— 29 N m {2.0— 3.0 kgf-m, 15— 21 ft lbf}
W 6 U 1 4 0 W 1 9
DRIVE SHAFT
W 6 U 1 4 0 W B 8
CLUTCH SWITCH INSPECTION [FS]
Inspection of Output Voltage
1. If the SST (104 Pin Breakout Box) are used,
check in the following order.
(1) Remove the PCM. (Refer to 01-40A
POWERTRAIN CONTROL MODULE (PCM)
REMOVAL/INSTALLATION [FS].)
(2) Connect the SST (104 Pin Breakout Box) to
the PCM as shown.
W 6 U 1 4 0 W B 9
(3) Tighten the connector bolt.
Tightening torque
7.9— 10.7 N m
{8 0 — 1 0 0 k g f c m , 6 9 .5 — 9 5 .4 in lbf}
(4) Turn the ignition switch to ON.
(5) Measure the voltage at PCM terminal 64.
0 1 -'
W 6 U 1 4 0 W 2 0
Specification
C o n d itio n
PCM te rm in a l 64
v o lta g e (V)
Other than neutral position
and clutch pedal released
B+
Neutral position or clutch
pedal depressed
Below 1.0
(6) If not as specified, check the related harness
and clutch switch continuity.
(7) If okay, c h e c k th e n e u tra l sw itch .
2. If the SSTs (NGS tester) are used, check in the
following order.
(1) Connect the SSTs (NGS tester) to the data
link connector.
BATTERY
W6U140WBH
,-28
DRIVE
SHAFT