Mazda MX-6 1998, Руководство по ремонту, Страница: 414 / 1282

MECHANICAL [FS]
49 B 0 1 4 001
2. H and tig h te n th e c a m s h a ft p u lle y bolts.
3. Hold the camshaft by using a wrench on the cast
hexagon as shown, and tighten each bolt.
Tightening torque
50— 60 N m {5.0— 6.2 kgf-m, 37— 44 ft lbf}
W 6 U 1 1 0 W B A
CAMSHAFT OIL SEAL
W 6 U 1 1 0 W B 8
6. Tighten the camshaft cap bolts in two or three
steps in the order shown.
Tightening torque
11.3— 14.2 N m
{115— 145 kgf cm, 100— 125 in lbf}
7. Verify that the camshaft settles horizontally when
two bearing cap bolts at No.3 journal are
tightened.
8. Apply clean engine oil to the camshaft oil seal.
9. Push the oil seal slightly in by hand.
10. Tap the oil seals in evenly by using the SST and a
hammer.
W 6 U 1 1 0 W B 7
HAMMER
CYLINDER HEAD
03—0.7 mm {0.012-0.027 In}
Camshaft Pulley Installation Note
1. Install the camshaft pulleys, positioning the dowel
pins as shwon.
DOWEL PIN
W 6 U 1 1 0 W B 9
0 1 -1 0A-11