Mazda MX-6 1998, Руководство по ремонту

Страница: 868 / 1282

AUTOMATIC TRANSAXLE [GF4A-EL]
O IL C O O LER REM OVAL/INSTALLATION [GF4A-EL]
W 6 U 5 1 7 W 3 4
1. Disconnect the negative battery cable.
2. Remove the fresh-air duct, air cleaner component. (Refer to 0 1 -1 3B INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION [KL].)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Install the fresh-air duct, air cleaner component. (Refer to 01-13B INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION [KL].)
6. Add ATF to the specified level. (Refer to 0 5 -1 7B AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT
[GF4A-EL].)
7. Connect the negative battery cable.
8. Inspect for oil leakage from the oil pipes and oil hoses.
9. Inspect the ATF level and condition. (Refer to 05-17B AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION
[GF4A-EL].)
10. Carry out the line pressure test. (Refer to 0 5 -1 7B MECHANICAL SYSTEM TEST [GF4A-EL], Line Pressure
Test.)
11. Carry out the road test. (Refer to 0 5 -1 7B ROAD TEST [GF4A-EL].)
N m {kgf-m , ft lbf)
W 6 U 5 1 7 W E V
1
Connector bolt
2 Washers
3 Hose clamp
p* Installation Note
4
Oil hose
w Installation Note
5 Oil pipe
c r Installation Note
6
Oil cooler
D- Installation Note
Oil Cooler Installation Note
1. The automatic transaxle oil cooler flushing must
be performed whenever a transaxle is removed for
service to remove existing fluid which may be
contaminated and to prevent contamination of
new fluid. The flushing must be performed after
installation of the overhauled replacement of the
transaxle.
2. Follow the instruction in the manufacture’s
publication for flushing the automatic transaxle oil
cooler.
3. Align the marks, and slide the oil hose onto the oil
pipe until it is full seated as shown.
0 5 -1 7 B -2 8
OIL COOLER
W6U517WEW