Mazda MX-6 1998, Руководство по ремонту

Страница: 1154 / 1282

GLASS/WINDOWS/MIRRORS
7. Apply protective tape to the dashboard to protect
it from damage.
8. Make a hole through the sealant from the inside of
the vehicle by using an awl.
9.
Pass the
SST
(piano wire) through the hole.
12. Remove the windshield.
13. Remove the spacers and dam.
CENTER
W 6 U 9 1 2 W B 0
10. Wind each end of the wire around a bar.
Note
• Use the entire length of piano wire to prevent
it from breaking when cutting through the
sealant.
11. Working with another person, saw through the
sealant around the edge of the glass, being
careful to not damage the vehicle body or the
dashboard. W 6 U 9 1 2 W B 2
W INDSHIELD INSTALLATION
Caution
•
To prevent the sealant from cracking or the
glass from being pushed out by air
pressure if a door is closed, open all of the
windows and leave them open until the
sealant has hardened.
1. Cut away the old sealant by using a razor knife so
that 1— 2 mm (0.04— 0.07 in} thickness of a
sealant remains around the circumference of the
frame. If all the sealant has come off in any one
place, apply some primer after degreasing, and
allow it
30 minutes to dry. Then put on new
sealant to create a 2 mm {0.08 in} layer.
W 6 U 9 1 2 W 1 8
CENTER
4. Install spacers into the holes.
5. Temporarily install the glass onto the body and
adjust the glass-to-body clearance.
6. Make a mark on the glass directly above the
V-notch of spacers.
7. Verify that the gap along the upper and sides are
7.3 mm {0.29 in}.
W 6 U 9 1 2 W B 3
2. Clean and degrease an approximately 50 mm
{2.0 in}
w id e
strip
a ro u n d
the circumference of the
glass and the bonding area on the body.
3. Securely bond a dam along the circumference of
the glass 8 mm {0.3 in}.
49 03 05 8 7 0 A
W 6 U 9 1 2 W B 1
B O D Y
7 .3
385
{
15
.
2
}
S P A C E R A
mm {in}
W6U912WB6
0 9 -1 2 -1 3