Mazda MX-6 1998, Руководство по ремонту

Страница: 1187 / 1282

SECURITY AND LOCKS
Steering Lock Replacement
When customer has brought two or more valid keys for old steering lock
Note
• When replacing the steering lock, the coil and keys should be replaced as a set.
IM M O B IL IZ E R U N IT
K EY 3, 4. 5
t
TO V E H IC L E H A R N E S S
W 6 U 9 1 4 W B 1
Note
• If no specific time interval is given, step should be performed within 30 seconds of the previous step.
1. Remove old steering lock. (Refer to 06-12 STEERING SHAFT COMPONENT DISASSEMBLY/ASSEMBLY.)
2. Connect new steering lock to ignition switch connector.
3. Connect old steering lock to coil connector as shown in figure.
4. Insert key 1 into old steering lock.
5. Insert key 3 into new steering lock and turn to ON then back to LOCK five times. Key should not remain ON
or LOCK for more than one second.
(1) Turn key 3 back to ON. Observe illumination of security light in instrument panel.
(2) Turn key 3 to LOCK. Observe security light goes out.
Note
• Operate next two steps within 30 seconds of step 5-(2).
6. Remove key 1 from old steering lock and insert key 2 into old steering lock.
7. Using key 3 of new steering lock, start engine. Observe security light illumination (for
1 — 2 seconds) and
engine continues to run.
(1) Turn key 3 to LOCK.
Note
• Operate next two steps within 30 seconds of step 7 - ( l) .
8. Disconnect coil connector from old steering lock, and reconnect coil connector to new steering lock.
9. Using key 3 of new steering lock, start engine. Observe security light illumination (for
1— 2 seconds) and
engine continues to run.
(1) Turn key 3 to LOCK and remove from steering lock.
10. Repeat step 9 with key 4.
11. Repeat step 9 with key 5.
12. Wait for 30 seconds to quit reprogram mode.
13. Install new steering lock.
When customer has brought only one or no valid key (code word is required)
W6U914WB0
0 9 -1 4 -1 9