Mazda MX-6 1998, Руководство по ремонту

Страница: 833 / 1282

AUTOMATIC TRANSAXLE [LA4A-EL]
W 6 U 5 1 7 W B P
24. Initially tighten the nut on the ball.
Remove the shifter pin.
25. Rotate the SST until the socket can be installed
on the nut. Tighten the manual valve detent lever
ball stud nut.
Tightening torque
11— 13 N m
{112— 133 kgf-cm, 97— 115 inlb f}
26. Remove the pin and SST.
27. Install the manual control lever component and
bolt.
Tightening torque
24— 30 N m {2.4— 3.1 kgf-m, 18— 22 ft lbf}
28. Install the control valve body cover gasket on the
case. Attach the cover to the case.
29. Install the fourteen mounting bolts in the sequence
shown.
Tightening torque
14— 18 N m
{143— 184 kgf-cm, 124— 159 in lbf}
Caution
•
If reusing the hose clamp, position it in the
original location on the hose and squeeze
the clamp lightly with large pliers to
ensure a tight fit.
30. Install the oil hose. (Refer to 0 5 -1 7A OIL
COOLER REMOVAL/INSTALLATION [LA4A-EL].)
31. Connect the solenoid body connector.
32. Connect the TR switch connector.
33. Install the splash shild.
34. Install the wheel and tire.
35. Install the fresh-air duct, air cleaner component.
(Refer to 0 1 -1 3A INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION [FS].)
36. Install the battery component. (Refer to 01-17
BATTERY REMOVAL/INSTALLATION.)
37. Fill the transaxle with the specified ATF after
installation. (Refer to 0 5 -1 7A AUTOMATIC
TRANSAXLE FLUID (ATF) REPLACEMENT
[LA4A-EL].)
38. Check for leakage of ATF from all connecting
points.
39. Connect the negative battery cable.
40. Carry out the mechanical system test. (Refer to
0 5 -1 7A MECHANICAL SYSTEM TEST
[LA4A-EL].)
41. Carry out the road test. (Refer to 0 5 -1 7A ROAD
TEST [LA4A-EL].)
W 6 U 5 1 7 W B R
22. Move the manual valve detent lever to the D
range position.
MANUAL VALVE
DETENT LEVER
“D"
23. Loosen the nut on the ball stud for the manual
valve detent lever actuating rod component.
W 6 U 5 1 7 W B Q
0 5 -1 7 A -2 8