manualshive.com logo in svg
background image

 
 

1 | 

P a g e

 

 

T6021

 

v1.1 02/2013

 

 

Installation Instructions for the Plug & Play Remote Start Package (EVOCHR5) 

 

For JEEP Liberty 2008-2012

 

 

Review the remote start installation manual for safety instructions! 
 

Overview 

Your kit consists of two modules – a remote start and an EVO-ALL interface module.  The EVO-ALL comes with a 
plug and play t-harness and is designed to make the installation of the remote start very easy.  There are a LOT of 
wires in your kit.  Because the EVO-ALL and remote start are designed to work together, you will use very few of 
them.  The only connections into the vehicle that are not direct plug-ins are the OPTIONAL parking light & hood pin 
features. 
 

STEP 1: Starting the installation 

 
1.  The bulk of the installation takes place right under the dash on the driver’s side. Begin by removing the plastic 

panel at the bottom of the dash, above where the pedals are.  The panel is held in with both bolts and clips.  Be 
careful not to break the panel – especially in cold weather.   

 
2.  Install the on-glass antenna.  Good locations for the antenna are at the top center of the windshield and along 

side the driver’s side windshield pillar. Tuck the wire inside the headliner and/or plastic molding and run it down 
the underside of the dash, near the parking brake release. If you have side curtain air bags, be sure to route the 
wire so it is behind the air bag, not in front of it. Plug the antenna into the remote start module.  

 
3.  We recommend permanently mounting the programming button.  Use a ¼” drill bit to make a hole - the top of the 

plastic kick panel on the left is a good location.  Make sure that the switch and the wires do not interfere with the 
parking brake.  Plug the programming switch into the remote start module. 

 
STEP 2: Plug in the T-Harness 

 
1.  Locate the immobilizer connector at the bottom of the key cylinder & disconnect the immobilizer connector 
2.  Connect the male connector of the T-harness to the immobilizer module 
3.  Connect the immobilizer connector to the female connector of the T-harness 
 

 

 

Отзывы: