2 Parameters
2.2 List of parameters
SINAMICS G120 CU250S-2 Control Units
362
List Manual, 09/2017, A5E33842890
Description:
Display and BICO output for the second status word of the monitoring functions.
Note:
For bit 10:
The torque threshold value 1 is set in p2174.
For bit 12:
This bit is reset after the fault cause disappears, even if the fault itself is still present.
Description:
Display and BICO output for the third status word of the monitoring functions.
Note:
For bit 00:
The speed threshold value 3 is set in p2161.
For bit 01:
The comparison value is set in p2141. We recommend setting the hysteresis (p2142) for canceling the bit to a value
lower than that in p2141. Otherwise, the bit is not reset.
For bit 11:
The torque threshold value 2 is set in p2194.
r2198.0...13
CO/BO: Status word monitoring 2 / ZSW monitor 2
Access level:
3
Calculated:
-
Data type:
Unsigned16
Can be changed:
-
Scaling:
-
Dyn. index:
-
Unit group:
-
Unit selection:
-
Func. diagram:
2536
Min Max
Factory
setting
- - -
Bit field:
Bit
Signal name
1 signal
0 signal
FP
00
|n_act| <= speed threshold value 5
Yes
No
8023
01
|n_act| > speed threshold value 5
Yes
No
8023
02
|n_act| <= speed threshold value 6
Yes
No
8023
03
|n_act| > speed threshold value 6
Yes
No
8023
04
|n_set| < p2161
Yes
No
8011
05
n_set > 0
Yes
No
8011
06
Motor blocked
Yes
No
8012
07
Motor stalled
Yes
No
8012
08
|I_act| < I_threshold value p2170
Yes
No
8022
09
|M_act| > torque threshold value 1 and
n_set reached
Yes
No
8023
10
|M_set| < torque threshold value 1
Yes
No
8012
11
Load in the alarm range
Yes
No
8013
12
Load in the fault range
Yes
No
8013
13
|M_act| > torque threshold value 1
Yes
No
8023
r2199.0...11
CO/BO: Status word monitoring 3 / ZSW monitor 3
Access level:
3
Calculated:
-
Data type:
Unsigned16
Can be changed:
-
Scaling:
-
Dyn. index:
-
Unit group:
-
Unit selection:
-
Func. diagram:
2537
Min Max
Factory
setting
- - -
Bit field:
Bit
Signal name
1 signal
0 signal
FP
00
|n_act| < speed threshold value 3
Yes
No
8010
01
f or n comparison value reached or
exceeded
Yes
No
8010
04
Speed setpoint - actual value deviation in
tolerance t_on
Yes
No
8011
05
Ramp-up/ramp-down completed
Yes
No
8011
11
Torque utilization < torque threshold value 2 Yes
No
8012
