Fig. 251:
Connecting analog inputs in series
The graphic above shows the terminal numbers for the analog input 3, but in principle it
works for all analog inputs which support a 0/4 to 20 mA signal.
6.3.10
Setup Expansion Modules at CAN 2
General notes
The easYgen is supporting several expansion modules for external analog and digital
terminals. It is possible to connect up to four Woodward IKDs for digital inputs and
outputs and some third party devices e.g. from Phoenix or WAGO for analog and digital
inputs and outputs. Also a combination of the devices listed is possible.
Configuring easYgen for expansion modules is split in two parts:
• One part is located at the external analog/digital inputs/outputs pages and defines
•
how many inputs/outputs are used and the scaling of the analog types. Refer to
chapters
for reference.
• The other part is located at the CAN2 interface pages and defines the Node IDs and
•
the types of external devices. Refer to chapter
╚═▷ “4.7.4.2.1 Expansion Modules at
for reference.
Additionally the external device must be configured to the correct baud rate and Node ID.
This could be done via DIP switches at Phoenix and WAGO, for the IKD with a Woodward
IKD configuration tool.
Supported external modules
Phoenix ...
Bus coupler
Discrete outputs
Discrete inputs
Analog outputs
Analog inputs
IL CAN BK
IB IL 24 DO 2
IB IL 24 DI 2
IB IL AO 2/SF (only)
IB IL AI 2/SF (only)
IB IL 24 DO 8
IB IL 24 DI 4
IB IL TEMP 2 UTH
(only)
IB IL 24 DO 16
IB IL 24 DI 8
IB IL TEMP 2 RTD
(only)
IB IL 24 DO 32 (only)
IB IL 24 DI 16
IB IL 24/230 DOR4/W
IB IL 24 DI 32 (only)
728
easYgen-3000XT Series
B37574
6 Application Field
6.3.10 Setup Expansion Modules at CAN 2
Released