Omron R88D-1SN01H-ECT, Руководство пользователя

Страница: 652 / 828

Appendices
A - 4 AC Servomotors/Servo Drives 1S-series with Built-in EtherCAT® Communications User’s Manual (I586)
State is indicated by the combination of bits in Statusword (6041 hex), as shown in the following table.
1S-series Servo Drives with built-in EtherCAT communications support the following modes of opera-
tion.
The operation mode is set in Modes of operation (
6060 hex). It is also given in Modes of operation dis-
play (6061
hex
).
You can check the operation modes supported by the Servo Drive with Supported drive modes (
6502 hex).
If an unsupported operation mode is specified, a Command Warning will occur.
State Coding
Status
Bit 6
sod
*1
*1. sod = switch on disabled
Bit 5
qs
*2
*2. qs = quick stop
Bit 4
ve
*3
*3. ve = voltage enabled
Bit 3
f
*4
*4. f = fault
Bit 2
oe
*5
*5. oe = operation enabled
Bit 1
so
*6
*6. so = switched on
Bit 0
rtso
*7
*7. rtso = ready to switch on
Not ready to switch on 0 0 Dis-
abled
0 0 0 0
Switch on disabled 1 1 Dis-
abled
0 0 0 0
Ready to switch on 0 1 Dis-
abled
0 0 0 1
Switched on 0 1 Dis-
abled
0 0 1 1
Operation enabled 0 1 Dis-
abled
0 1 1 1
Fault reaction active 0 1 Dis-
abled
1 1 1 1
Fault 0 1 Dis-
abled
1 0 0 0
A-1-2 Modes of Operation
Modes of
operation
Description
csp
Cyclic synchronous position mode
csv
Cyclic synchronous velocity mode
cst
Cyclic synchronous torque mode
pp
Profile position mode
pv
Profile velocity mode
hm
Homing mode