Rohde & Schwarz CMW-KE100, User Manual

Page: 517 / 938

CDMA2000 Signaling
R&S
®
CMW-KM8xx/-KS8xx
517 User Manual 1173.9511.02 ─ 12
Select as fixed Target
Sets the selected measurement as fixed target of the softkey. The softkey label indi-
cates the measurement name and switches directly to the selected target without
opening the dialog box.
You can still change the target measurement or re-enable the dialog box using the
configuration menu, see
chapter 4.3.11, "Shortcut Configuration" , on page 563.
Go to / Cancel
Click "Go to" to switch to the selected measurement or "Cancel" to abort.
4.3.4 General Settings
These settings are located at the very top of the configuration dialog.
Fig. 4-28: General settings
Scenario, Fading
Different test scenarios require different sets of parameters. Selecting a scenario
hides/shows parts of the GUI as required by the scenario.
The parameter is only configurable while the forward signal is switched off.
●
Standard Cell :
Standard CDMA2000 cell with only one RF output path.
●
Hybrid Mode :
Scenario to enable Hybrid Mode on a Single SUU .
Revision B is not supported in hybrid mode with one SUU. If revision B is required,
the dual SUU setup has to be chosen.
●
Standard Cell Fading :
"Standard Cell" plus fading and/or AWGN insertion.
Additional parameter "Fading" selects between external fading via a connected
R&S AMU200A and internal fading via an internal fader I/Q board.
For further reference:
●
chapter 4.2.1, "Test Setups" , on page 453
●
chapter 4.2.5, "Hybrid Mode" , on page 460
●
chapter 4.2.6, "External Fading" , on page 463
●
chapter 4.2.7, "Internal Fading" , on page 464
The individual scenarios are only offered for selection if the required software and
hardware options are available, as listed in the following table.
Table 4-18: Required hardware and software options
SUU TX I/Q Board Software Options
"Standard Cell" 1 1 - -
"Hybrid Mode" 1 1 - KS888
"Standard Cell Fading, External" 1 1 B510x or B520x -
GUI Reference
深圳德标仪器
135-1095-0799