1xEV-DO Measurements
R&S
®
CMW-KM8xx/-KS8xx
398
User Manual 1173.9511.02 ─ 12
Usage:
Query only
Firmware/Software:
V2.0.20
Options:
R&S CMW-KM012
CALCulate:EVDO:MEAS<i>:MEValuation:LIST:ACP:EXTended:AVERage?
CALCulate:EVDO:MEAS<i>:MEValuation:LIST:ACP:EXTended:CURRent?
CALCulate:EVDO:MEAS<i>:MEValuation:LIST:ACP:EXTended:MAXimum?
CALCulate:EVDO:MEAS<i>:MEValuation:LIST:ACP:EXTended:MINimum?
CALCulate:EVDO:MEAS<i>:MEValuation:LIST:ACP:EXTended:SDEViation?
FETCh:EVDO:MEAS<i>:MEValuation:LIST:ACP:EXTended:AVERage?
FETCh:EVDO:MEAS<i>:MEValuation:LIST:ACP:EXTended:CURRent?
FETCh:EVDO:MEAS<i>:MEValuation:LIST:ACP:EXTended:MAXimum?
FETCh:EVDO:MEAS<i>:MEValuation:LIST:ACP:EXTended:MINimum?
FETCh:EVDO:MEAS<i>:MEValuation:LIST:ACP:EXTended:SDEViation?
Returns all ACP value results in list mode. To define the statistical length for
AVERage
,
MAXimum
,
MINimum
calculation and enable the calculation of the results use the com-
mand
CONFigure:EVDO:MEAS<i>:MEValuation:LIST:SEGMent<no>:
.
The ranges indicated below apply to all results except standard deviation results. The
minimum for standard deviation results equals 0. The maximum equals the width of the
indicated range divided by two. Exceptions are explicitly stated.
The values listed below in curly brackets {} are returned for each active segment:
{...}
seg 1
, {...}
seg 2
, ..., {...}
seg n
. The number of active segments n is determined by
CONFigure:EVDO:MEAS<i>:MEValuation:LIST:COUNt
.
The values described below are returned by
FETCh
and
READ
commands.
CALCulate
commands return limit check results instead, one value for each result listed below.
The number to the left of each result parameter is provided for easy identification of the
parameter position within the result array.
For the "Out of Tolerance" and "Code Channel Filter Match Ratio" results retrieved via
the
CURRent
,
AVERage
and
MAXimum
command are identical.
Return values:
<1_Reliability>
Conventions and General Information
. In list mode, a zero relia-
bility indicator indicates that the results in all measured seg-
ments are valid. A non-zero value indicates that an error occur-
red in at least one of the measured segments.
{<2_SegReliability>
The segment reliability indicates whether one of the following
exceptions occurred in this segment:
0:
No error
3:
Signal overflow
4:
Signal low
8:
Synchronization error
If a combination of exceptions occurs, the most severe error is
indicated.
Command Reference
深圳德标仪器
135-1095-0799
