Freescale Semiconductor MC9S12ZVHL32, Reference Manual

Page: 269 / 874

Chapter 7 S12 Clock, Reset and Power Management Unit (S12CPMU_UHV_V5)
S12ZVHY/S12ZVHL Family Reference Manual, Rev. 1.05
Freescale Semiconductor 269
7.3.2.21 S12CPMU_UHV_V5 IRC1M Trim Registers (CPMUIRCTRIMH /
CPMUIRCTRIML)
Read: Anytime
Write: Anytime if PROT=0 (CPMUPROT register). Else write has no effect
NOTE
Writes to these registers while PLLSEL=1 clears the LOCK and UPOSC
status bits.
Module Base + 0x0018
15 14 13 12 11 10 9 8
R
TCTRIM[4:0]
0
IRCTRIM[9:8]
W
Reset F F F F F 0 F F
After de-assert of System Reset a factory programmed trim value is automatically loaded from the Flash memory to
provide trimmed Internal Reference Frequency f
IRC1M_TRIM
.
Figure 7-27. S12CPMU_UHV_V5 IRC1M Trim High Register (CPMUIRCTRIMH)
Module Base + 0x0019
7 6 5 4 3 2 1 0
R
IRCTRIM[7:0]
W
Reset F F F F F F F F
After de-assert of System Reset a factory programmed trim value is automatically loaded from the Flash memory to
provide trimmed Internal Reference Frequency f
IRC1M_TRIM
.
Figure 7-28. S12CPMU_UHV_V5 IRC1M Trim Low Register (CPMUIRCTRIML)
Table 7-27. CPMUIRCTRIMH/L Field Descriptions
Field Description
15-11
TCTRIM[4:0]
IRC1M temperature coefficient Trim Bits
Trim bits for the Temperature Coefficient (TC) of the IRC1M frequency.
Table 7-28 shows the influence of the bits TCTRIM[4:0] on the relationship between frequency and temperature.
Figure 7-30 shows an approximate TC variation, relative to the nominal TC of the IRC1M (i.e. for
TCTRIM[4:0]=0x00000 or 0x10000).
9-0
IRCTRIM[9:0]
IRC1M Frequency Trim Bits — Trim bits for Internal Reference Clock
After System Reset the factory programmed trim value is automatically loaded into these registers, resulting in a
Internal Reference Frequency f
IRC1M_TRIM
.See device electrical characteristics for value of f
IRC1M_TRIM
.
The frequency trimming consists of two different trimming methods:
A rough trimming controlled by bits IRCTRIM[9:6] can be done with frequency leaps of about 6% in average.
A fine trimming controlled by bits IRCTRIM[5:0] can be done with frequency leaps of about 0.3% (this trimming
determines the precision of the frequency setting of 0.15%, i.e. 0.3% is the distance between two trimming
values).
Figure 7-29 shows the relationship between the trim bits and the resulting IRC1M frequency.