Chapter 10 Analog-to-Digital Converter (ADC12B_LBA_V1)
S12ZVHY/S12ZVHL Family Reference Manual Rev. 1.05
372
Freescale Semiconductor
5
RSTA
Restart Event (Restart from Top of Command Sequence List)
— This bit indicates that a Restart Event is
executed. The ADC loads the conversion command from top of the active Sequence Command List when no
conversion or conversion sequence is ongoing. This bit is cleared when the first conversion command of the
sequence from top of active Sequence Command List has been loaded into the ADCCMD register.
This bit can only be set if bit ADC_EN is set.
This bit is cleared if bit ADC_EN is clear.
Data Bus Control:
This bit can be controlled via the data bus if access control is configured accordingly via ACC_CFG[1:0].
Writing a value of 1’b0 does not clear the flag.
Writing a one to this bit does not clear it but causes an overrun if the bit has already been set. See also
for
more details.
Internal Interface Control:
This bit can be controlled via the internal interface Signal “Restart” if access control is configured accordingly via
ACC_CFG[1:0]. After being set an additional request via internal interface Signal “Restart“ causes an overrun.
See conversion flow control in case of overrun situations for more details.
General:
In conversion flow control mode “Trigger Mode” when bit RSTA gets set bit TRIG is set simultaneously if one of
the following has been executed:
- “End Of List” command type has been executed or is about to be executed
- Sequence Abort Event
0 Continue with commands from active Sequence Command List.
1 Restart from top of active Sequence Command List.
4
LDOK
Load OK for alternative Command Sequence List
— This bit indicates if the preparation of the alternative
Sequence Command List is done and Command Sequence List must be swapped with the Restart Event. This
bit is cleared when bit RSTA is set (Restart Event executed) and the Command Sequence List got swapped.
This bit can only be set if bit ADC_EN is set.
This bit is cleared if bit ADC_EN is clear.
This bit is forced to zero if bit CSL_BMOD is clear.
Data Bus Control:
This bit can be controlled via the data bus if access control is configured accordingly via ACC_CFG[1:0].
Writing a value of 1’b0 does not clear the flag.
To set bit LDOK the bits LDOK and RSTA must be written simultaneously.
After being set this bit can not be cleared by writing a value of 1’b1. See also
Section 10.5.3.2.6, “Conversion
flow control in case of conversion sequence control bit overrun scenarios
for more details.
Internal Interface Control:
This bit can be controlled via the internal interface Signal “LoadOK” and “Restart” if access control is configured
accordingly via ACC_CFG[1:0]. With the assertion of Interface Signal “Restart” the interface Signal “LoadOK” is
evaluated and bit LDOK set accordingly (bit LDOK set if Interface Signal “LoadOK” asserted when Interface
Signal “Restart” asserts).
General:
Only in “Restart Mode” if a Restart Event occurs without bit LDOK being set the error flag LDOK_EIF is set except
when the respective Restart Request occurred after or simultaneously with a Sequence Abort Request.
The LDOK_EIF error flag is also not set in “Restart Mode” if the first Restart Event occurs after:
- ADC got enabled
- Exit from Stop Mode
- ADC Soft-Reset
0 Load of alternative list done.
1 Load alternative list.
Table 10-9. ADCFLWCTL Field Descriptions (continued)
Field
Description
