R&S RTO6, Руководство пользователя

Страница: 883 / 2677

Protocol analysis
R&S
®
RTO6
883 User Manual 1801.6687.02 ─ 05
Virtual Channel
Triggers on a specific virtual channel, an independent data stream for up to four periph-
erals.
Remote command:
TRIGger<m>:DPHY:HSVC
on page 2254
Data Type
Sets the specified data type to be triggered on. The data type setup consists of the
condition and one or two data patterns.
In binary format, use the following characters: 1; 0; or X (do not care). To enter the pat-
tern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor" ,
on page 493.
"Condition" Sets the comparison condition to a specific value or a range.
"Data Min/
Data" Specifies the value or sets the start value of a range.
"Data Max" Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
TRIGger<m>:DPHY:DTYPe:CONDition
on page 2251
TRIGger<m>:DPHY:DTYPe:MAX
on page 2251
TRIGger<m>:DPHY:DTYPe:MIN
on page 2251
Word Count
Sets the specified specific word count to be triggered on. The word count setup con-
sists of the condition and one or two data patterns.
In binary format, use the following characters: 1; 0; or X (do not care). To enter the pat-
tern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor" ,
on page 493.
"Condition" Sets the comparison condition to a specific value or a range.
"Data Min/
Data" Specifies the value or sets the start value of a range.
"Data Max" Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
TRIGger<m>:DPHY:WCOunt:CONDition
on page 2254
TRIGger<m>:DPHY:WCOunt:MAX
on page 2254
TRIGger<m>:DPHY:WCOunt:MIN
on page 2255
Data Value
Set the specified data value to be triggered on. The data value setup consists of the
condition and one or two data value patterns.
In binary format, use the following characters: 1; 0; or X (do not care). To enter the pat-
tern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor" ,
on page 493.
"Condition" Sets the comparison condition to a specific value or a range.
D-PHY (option R&S RTO6-K580)