R&S RTO6, Руководство пользователя

Страница: 50 / 2677

Getting started
R&S
®
RTO6
50 User Manual 1801.6687.02 ─ 05
The waveform is now active, selected, and is shown in the diagram.
Remote command:
CHANnel<m>:STATe
on page 1337
To select a waveform
► Choose one of the following ways:
● Tap the waveform in the waveform diagram.
● To select a channel, reference, or math waveform, press the corresponding
key.
● Tap the signal icon.
Note: Zoom waveforms in zoom diagrams cannot be selected.
To minimize a waveform
► Choose on of the following ways:
● Tap the "Minimize" icon in the upper right corner of the waveform's signal label
in the signal bar.
● Drag the waveform from the diagram to the signal bar.
The waveform disappears from the diagram and the signal preview is shown in the
signal icon.
Remote command:
LAYout:SIGNal:UNASsign
on page 1306
► To set the waveform back to its previous diagram immediately, use "Undo".
To arrange a waveform using the SmartGrid
See Chapter 3.3.5, "Rohde & Schwarz SmartGrid" , on page 50.
To switch off a waveform
► Do one of the following:
● To switch off a signal preview, tap the "Close" icon in the upper right corner of
the minimized signal view.
● Disable "Channel" in the "Vertical" > "Setup" tab.
● Tap the "Delete" icon (Recycle bin) in the toolbar, and then the waveform.
If several waveforms overlap or lie close together, the upper (selected) wave-
form is switched off.
Remote command:
CHANnel<m>:STATe
on page 1337
3.3.5 Rohde & Schwarz SmartGrid
The Rohde & Schwarz SmartGrid helps to create and arrange the diagrams on the
screen with drag&drop. The diagram layout depends on the position where you drop
the signal icon, in relation to an existing diagram.
Operating the instrument