SD710 Series Servo Drive User Manual Chapter 3 Wiring and Installation
8
explanation of how to wire the spring-type terminals.
（
1
）
Removing the Terminal Block from the Servo Drive
The terminal block must be removed from the Servo Drive before wiring. Direct wiring without removing the terminal block
may cause damage to the Servo Drive.
（
2
）
Wire Stripping
Peel off the outer skin of the wire used 8mm to 9mm.
Figure 3.7 Cable stripping diagram
（
3
）
Open the Wire Insertion Slot in the Terminal Block
There are two ways to open the wire insertion slot, as shown below.
⚫
Pry open the slot with the control bar that comes with the servo driver (as shown in Figure 3.8,
drawing a).
⚫
Insert a "slotted" screwdriver into the terminal opening (end width 3.0mm to 3.5mm) and press
firmly to open the slot (as shown in Figure b).
a
.
Pry open the slot with the matching control bar b. Use a screwdriver to open the slot by pressing
Figure 3.8 Pressed wire slot usage
（
4
）
Insert the Wire into the Slot
Once the slot is open, the wire is inserted and then the slot is closed by releasing the pressure of the control bar or
screwdriver.
（
5
）
Reinstall the Terminal Block into the Servo Drive
After connecting all terminals, plug the terminals back into their original positions on the servo drive.
Cautions
● Do not operate with electricity when wiring.
● Do not short
-circuit adjacent cores when inserting cables.
● The stripped wire ends need to be twisted tightly to ensure that no core is exposed after inserting
into the terminal.
！
