SD710 Series Servo Drive User's Manual Chapter 7 Auxiliary Functions
24
assist
meri
torious
d
eed
or
service
capab
le
3
Press the "DATA/SHIFT" key for about 1 second, and the
command-type intelligent adjustment function symbol is
displayed as shown on the left picture.
4
Press the "MODE/SET" key to enter the interface for
setting parameters related to the advanced adjustment
function.
5
The "UP", "DOWN" and "Data/Shift" keys are used to
adjust the corresponding selector switches.
Inertia recognition switch
0
unrecognizable
1
identify
Mode Selection
1
Combining responsiveness
and stability tuning
2
Positioning-specific
adjustments
3
Overshoot suppression on
the basis of position-
specific adjustment
Institution type
1
Conveyor construction
2
Ball Screw Structure
3
Rigid system
Use parameter selection during
adjustment
0
Current value
1
Default
6
Press the "MODE/SET" key to enter the inertia recognition
interface, as shown in the figure on the left. The drive
enters the ON state and the motor locks the shaft.
7
(blinking)
Inertia recognition is started by pressing the "UP" button.
8
-
After the normal recognition of the completed inertia, the
corresponding inertia value will be displayed.
The inertia ratio identified in the example is 120%.
Note: If you wish to terminate the subsequent action,
press the "DATA/SHIFT" key for about 1 second to return
to the Fn201 state.
9
The parameter adjustment is started by pressing the "UP"
key.
After entering the parameter rectification, the display
screen is shown on the left picture.
MODE/SET
Data/
MODE/SET
Data/
MODE/SET
Data/
MODE/SET
Data/
MODE/SET
Data/
MODE/SET
Data/
