Dell Force10 S4810P, Справочное руководство

Страница: 322 / 1637

Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Usage
Information
If you configure the
set next-hop
command, its configuration takes precedence over the
neighbor next-hop-self
command in the ROUTER BGP mode.
If you configure the
set next-hop
command with the interface’s IP address (either
Loopback or physical), the software declares the route unreachable.
Related
Commands
match ip next-hop – redistributes routes that match the next-hop IP address.
neighbor next-hop-self – configures the routers as the next hop for a BGP neighbor.
set origin
Configure a filter to manipulate the BGP ORIGIN attribute.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax set origin {igp | egp | incomplete}
To delete an ORIGIN attribute setting, use the
no set origin
command.
Parameters
egp Enter the keyword
egp
to set routes originating from outside the local
AS.
igp Enter the keyword
igp
to set routes originating within the same AS.
incomplete Enter the keyword
incomplete
to set routes with incomplete
routing information.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
322