Dell Force10 S4810P, Справочное руководство

Страница: 520 / 1637

weight
Enter a number as the weight. The range is 0 to 65535. The default is
0.
Defaults 0
Command Modes ROUTER BGP
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
Usage
Information In the FTOS best path selection process, the path with the highest weight value is preferred.
NOTE: Reset the neighbor connection (the
clear ip bgp *
command) to apply the
weight to the connection and recompute the best path.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
C-Series, E-Series
Syntax network ipv6-address prefix-length [route-map map-name ]
To remove a network, use the
no network ip-address mask [route-map map-
name ]
command.
Parameters
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format followed by the prefix
length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
mask
Enter the mask of the IP address in the slash prefix length format (for
example, /24). The mask appears in command outputs in dotted
decimal format (A.B.C.D).
route-map
map-
name
(OPTIONAL) Enter the keywords
route-map
followed by the name of
an established route map. Only the following ROUTE-MAP mode
commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is
deny
(to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
520