Dell Force10 S4810P, Справочное руководство

Страница: 1316 / 1637

Parameters
access-group-
name Enter the ACL name whose contents are used as the match criteria in
determining if packets belong to the class specified by class-map.
set-ip-dscp value (OPTIONAL) Enter the keywords
set-ip-dscp
followed by the IP
DSCP value. The matched traffic is marked with the DSCP value. The
range is 0 to 63.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Added the
DSCP Marking
option support on the S-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.5.1.0 Added support for the
DSCP Marking
option.
pre-Version
6.1.1.1 Introduced on the E-Series.
Usage
Information You must enter the
class-map
command in order to access this command. After the class
map is identified, you can configure the match criteria. For class-map match-any, a maximum
of five ACL match criteria are allowed. For
class-map match-all
, only one ACL match
criteria is allowed.
Related
Commands
class-map – identifies the class map.
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax match ip dscp dscp-list [[multicast] set-ip-dscp value ]
To remove a DSCP value as a match criteria, use the
no match ip dscp dscp-list
[[multicast] set-ip-dscp value ]
command.
Parameters
dscp-list Enter the IP DSCP value(s) that is to be the match criteria. Separate
values by commas — no spaces ( 1,2,3 ) or indicate a list of values
separated by a hyphen (1-3). The range is 0 to 63.
multicast (OPTIONAL) Enter the keyword
multicast
to match against
multicast traffic.
NOTE: This option is not supported on C-Series or S-Series.
1316