Dell Force10 S4810P, Справочное руководство

Страница: 266 / 1637

monitor (OPTIONAL) Enter the keyword
monitor
when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface.
NOTE: For more information, refer to the Flow-based Monitoring
section in the Port Monitoring chapter of the
FTOS Configuration
Guide
.
fragments Enter the keyword
fragments
to use ACLs to control packet
fragments.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
Version 8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Added the
monitor
option.
Version 6.5.10 Expanded to include the optional QoS
order
priority for the ACL
entry.
Usage
Information
The
order
option is relevant in the context of the Policy QoS feature only. For more
information, refer to the “Quality of Service” chapter of the FTOS Configuration Guide .
When you use the
log
option, the CP processor logs details about the packets that match.
Depending on how many packets match the log entry and at what rate, the CP may become
busy as it has to log these packets’ details.
The
monitor
option is relevant in the context of flow-based monitoring only. For more
information, refer to Port Monitoring .
You cannot include IP, TCP, or UDP filters in an ACL configured with ARP filters.
NOTE: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
permit ether-type
Configure a filter that allows traffic with specified types of Ethernet packets. This command is supported only on 12-port
GE line cards with SFP optics. For specifications, refer to your line card documentation.
E-Series
Syntax permit ether-type protocol-type-number { destination-mac-address
mac-address-mask | any} vlan vlan-id { source-mac-address mac-
address-mask | any} [count [byte] | log] [order] [monitor]
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command if you know the filter’s sequence
number.
• Use the
no permit ether-type protocol-type-number
{ destination-mac-address mac-address-mask | any} vlan
266