Dell Force10 S4810P, Справочное руководство

Страница: 387 / 1637

Parameters
ipv4-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group.
Defaults Disabled.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced
Usage
Information When you enable fall-over, BGP keeps track of IP or IPv6 ability to reach the peer remote
address and the peer local address. Whenever either address becomes unreachable (for
example, no active route exists in the routing table for the peer IP or IPv6 destination/local
address), BGP brings down the session with the peer.
Related
Commands show ip bgp neighbors – displays information on the BGP neighbors.
neighbor filter-list
Configure a BGP filter based on the AS-PATH attribute.
C-Series, E-Series, S-Series, Z-Series
Syntax neighbor { ip-address | peer-group-name } filter-list as-path-
name {in | out}
To delete a BGP filter, use the
no neighbor { ip-address | peer-group-name }
filter-list as-path-name {in | out}
command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to apply the filter to all routers in the
peer group.
as-path-name
Enter the name of an established AS-PATH access list (up to 140
characters).
If the AS-PATH access list is not configured, the default is permit
(allow routes).
in Enter the keyword
in
to filter inbound BGP routes.
out Enter the keyword
out
to filter outbound BGP routes.
Defaults Not configured.
Command Modes
• ROUTER BGP
387