Dell Force10 S4810P, Справочное руководство

Страница: 1327 / 1637

wred-profile
name
(OPTIONAL) Enter the keywords
wred-profile
followed by your
WRED profile name in character format (16 character maximum). Or
use one of the pre-defined WRED profile names.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g,
wred_teng_y, wred_teng_g.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.8.0 Introduced on the S4810.
Version 7.4.1.0
and 6.5.3.0 Introduced on the E-Series.
Usage
Information
This command does not uniquely identify a queue, but rather identifies only a set of queues.
The WRED Curve is applied to all eight ingress Multicast queues.
NOTE: The
multicast-bandwidth
option is not supported on queue ingress. If you
attempt to use the
multicast-bandwidth
option, the following reject error message
is generated:
% Error:Bandwidth-percent is not allowed for
ingress multicast
.
Related
Commands show queue statistics ingress – displays the ingress queue statistics.
rate-limit
Specify the rate-limit functionality on outgoing traffic as part of the selected policy.
E-Series
Syntax rate-limit [kbps] committed-rate [ burst-KB ] [peak [kbps] peak-
rate [ burst-KB ]]
Parameters
kbps Enter the keyword
kbps
to specify the rate limit in Kilobits per
second (Kbps). On the E-Series, Force10 recommends using a value
greater than or equal to 512 as lower values do not yield accurate
results. The range is 0 to 10000000. The default granularity is
Megabits per second (Mbps).
committed-rate Enter the bandwidth in Mbps. The range is 0 to 10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is 16 to 200000. The
default is 50.
peak peak-rate (OPTIONAL) Enter the keyword
peak
followed by a number to specify
the peak rate in Mbps. The range is 0 to 10000. The default is the
same as designated for
committed-rate
.
Defaults Burst size is 50 KB.
peak-rate
is by default the same as
committed-rate
. Granularity
for
committed-rate
and
peak-rate
is Mbps unless you use the
kbps
option.
1327