Dell Force10 S4810P, Справочное руководство

Страница: 56 / 1637

2. Enter the
configure
command. The prompt changes to include (conf).
From this mode, you can enter INTERFACE mode by using the
interface
command.
INTERFACE Mode
You must use INTERFACE mode to configure interfaces or IP services on those interfaces. An interface can be physical
(for example, a Gigabit Ethernet port) or virtual (for example, the Null interface).
To enter INTERFACE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
interface
command and then enter an interface type and interface number that is available on the
switch.
The prompt changes to include the designated interface and slot/port number. For example:
Prompt Interface Type
FTOS(conf-if)# INTERFACE mode
FTOS(conf-if-
gi-0/0)# Gigabit Ethernet interface followed by the slot/port information
FTOS(conf-if-
te-0/0)# Ten-Gigabit Ethernet interface followed by slot/port information
FTOS(conf-if-
fo-0/0)# Forty-Gigabit Ethernet interface followed by slot/port information
FTOS(conf-if-
lo-0)# Loopback interface number
FTOS(conf-if-
nu-0)# Null Interface followed by zero
FTOS(conf-if-
po-0)# Port-channel interface number
FTOS(conf-if-
vl-0)# VLAN Interface followed by VLAN number (range 1–4094)
FTOS(conf-if-
so-0/0)# SONET interface followed by slot/port information
FTOS(conf-if-
ma-0/0)# Management Ethernet interface followed by slot/port information
FTOS(conf-if-
range)# Designated interface range (used for bulk configuration).
LINE Mode
You must use LINE mode to configure the console or virtual terminal parameters.
To enter LINE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
line
command. Include the keywords
console
or
vty
and their line number available on the switch.
The prompt changes to include (config-line-console) or (config-line-vty).
You can exit this mode by using the
exit
command.
56